W10600 Code

Check Wallke W10600 e-Bike Error Code :

Indication conditions

Sensor initialization could not be completed normally.

Operational restrictions being displayed

Assist will not be provided when riding.

Press the battery power button to turn the power OFF and then ON again without placing your feet on the pedals.

If the warning persists after the first attempt, repeat the same operation until it disappears.

The sensor also initializes when the bicycle is moving. If you keep riding the bicycle the situation may improve.

If the situation does not improve, request the following at your place of purchase or a distributor.

Adjust the chain tension.

With the rear wheel lifted off the ground, turn the pedals to freely spin the rear wheel.

The bicycle speed target is from 10 km/h to 20 km/h.

Next, repeat the following operation: stop the crank at the desired position for approximately 2 seconds, accelerate again and spin freel

Codes List :

eBike Brands :