24 Code
Check Omnium 24 e-Bike Error Code :
Error Type:
Motor communication or hall sensor error
Source Of Error
Check the motor cable connection point by the chainstay. Check the cable connection, disconnect carefully, and make sure it is free from grit or contaminants, properly aligned, and firmly connected. This error might appear if you don't reconnect the cable after removing the rear wheel (for example, after changing a flat tire, or transporting your bike in or on on your vehicle). At least one of the motor phase wires has been damaged or is temporarily disconnected. Another possible cause is damage to the motor cable as it exits the axle, perhaps if the wheel was dropped on the cable or something hit or pulled the cable.